Reeves G2 series Operation Manual page 78

Operation & Maintenance w/IPB
INSTALLATION OF THE ELECTRONIC IGNITER ASSEMBLY (CONT):
h. Reinstall the electronic igniter and base plate assembly; ensure the igniter springs are contacting the
electrodes tangs and electrical wires are not pinched.
i. Using a 5/16" open end wrench, install and tighten (2) hex head screws.
j. Using a cross-point screwdriver, install and tighten (2) cross-point screws.
k. Reconnect power cord into power supply.
l. Perform operations check.
END OF TASK
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
0014-12
0014
DHS Systems LLC