Pmcs Introduction - Reeves G2 series Operation Manual

Operation & Maintenance w/IPB
GENERAL
This Work Package provides data necessary to keep the G2 Series Decontamination Water Heater operational ready.
PMCS are performed to keep the equipment in operational condition. The checks are used to find, correct, and report
problems. Personnel trained on the equipment are required to perform the tasks as indicated in Operator PMCS (WP
0013), Table 1. PMCS are performed by the operator each time the equipment is operated.
WARNINGS AND CAUTIONS
Special attention should be paid to the WARNINGS and CAUTIONS appearing in the operator PMCS table. A
WARNING means someone could be injured. A CAUTION means equipment could be damaged.
EXPLANATION OF TABLE ENTRIES
Item Number – Numbers in this column are for reference. When completing DA Form 2404/ DA Form 5988E
(Equipment Inspection and Maintenance Worksheet), include the item number for the check/service indicating a fault.
Item numbers appear in the order in which the checks/services are performed for the interval listed.
Interval – This column indicates when a procedure must be performed (i.e., Before, Daily, or Monthly).
Item to Be Checked or Serviced – This Column identifies the item that is to be checked or serviced.
Procedure – This column describes the procedure that must be followed to ensure that the equipment is capable of
performing its intended mission.
Equipment Not Ready/Available If – This column lists conditions that makes the G2 Series Decontamination Water
Heater not fully mission capable. If the problem can be fixed using the troubleshooting procedures and/or
maintenance procedures in this manual, do so. If not, document the items not able to be fixed on DA Form 2404/DA
Form 5988E for operator maintenance. For further information on how to use this form, see DA PAM 750-8. Be sure
to observe and annotate all special circumstances that appear/occur.
Perform daily as well as before PMCS if you are the assigned operator but have not
operated the equipment since the last weekly inspection, or if you are operating the
equipment for the first time.
If the equipment must be kept in continuous operation, only perform those
procedures that will not disturb operation. Complete checks and services when the
equipment is shut down.
END OF WORK PACKAGE
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Decontamination Water Heater
OPERATOR MAINTENANCE INSTRUCTIONS
G2 SERIES DECONTAMINATION WATER HEATER

PMCS INTRODUCTION

NOTE
0012-1/2 blank
0012
DHS Systems LLC