Reeves G2 series Operation Manual page 33

Operation & Maintenance w/IPB G2 Series Decontamination Water Heater 0005
PRE-START INSPECTION PROCEDURES
Before starting the water heater, perform the following procedures:
1. Inspect the electrical cords for damages. If cord is damaged, DO NOT USE CORD. Replace cord before starting
water heater.
2. Check all hose connections to ensure they are securely tightened.
3. Inspect the system for water leaks and fuel leaks. If fuel leak is detected, DO NOT START THE UNIT. Be sure
that all damaged parts are replaced and that the mechanical problems are corrected prior to operation of the unit. If
you require service, contact Reeves EMS (see WP 0001 for contact information).
END OF TASK
END OF WORK PACKAGE
Part Number: 1006375 0005-5/6 blank DHS Systems LLC
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.