Reeves G2 series Operation Manual page 31

Operation & Maintenance w/IPB
POWER CORD CONNECTION (CONT)
6. EXTENSION CORDS:
e) USING EXTENSION CORDS IS NOT RECOMMENDED. If an extension cord must be used, it must
be plugged into a GFCI found in circuit boxes or protected receptacles. When using an extension
cord, consult a qualified electrician to determine the proper wire gauge needed for the length of the
extension cord.
f) SINGLE PHASE – use only three wire extension cords that have three prong grounding type plugs
and three pole cord connectors that accept the plug from the water heater.
g) THREE PHASE – use only four wire extension cords that have four prong grounding type plugs and
four pole cord connectors that accept the plug from the water heater.
If the use of an extension cord is a must, only use extension cords
that are intended for outdoor use. These extension cords are
identified by a marking "Acceptable for use with Outdoor Appliances".
Use only extension cords having an electrical rating not less than the
rating of the water heater. Do Not Use Damaged Extension Cords.
Examine extension cord before using and replace if damaged. Do not
abuse extension cords and do not pull on any cord to disconnect.
Always connect or disconnect the extension cord from the receptacle
before connecting or disconnecting the unit from the extension cord.
7. Ensure the area between the water heater power cord and outlet is kept dry.
8. Insert the male plug into a grounded AC outlet. DO NOT use an adapter or remove the grounding plug.
BURNER FUEL TANK
DO NOT smoke while fueling. DO NOT fill the fuel tank while water
heater is running or hot. Allow water heater a minimum of five minutes
to cool before refueling. DO NOT fill fuel tank to point of overflowing.
1. Before fueling, review the following "Risks of Fire:
a) Always operate water heater in a well ventilated area free of flammable vapors, gases, or other
combustible materials.
b) Do Not store the water heater near an open flame or any equipment such as stoves, furnace, water
heater, etc., which utilizes a pilot light or sparking device
c) Do Not smoke while filling burner fuel tank.
d) Never fill the burner fuel tank while the water heater is operating or hot. Always allow to cool five
minutes before refueling.
e) Do Not refuel in a poorly ventilated area.
f) Always refuel slowly to avoid the possibility of spilled fuel which may cause a risk of fire.
2. Locate all the Safety Decals on your water heater and heed their warnings.
3. Fill the burner fuel tank with good quality, clean No. 1 or No. 2 fuel oil / diesel or kerosene. Do Not Use Gasoline.
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
NOTE
DANGER
Risk of Fire
0005-3
0005
DHS Systems LLC