Reeves G2 series Operation Manual page 74

Operation & Maintenance w/IPB
INSTALLATION OF FUEL PUMP/SOLENOID:
2. Installing the fuel pump/solenoid as follows:
a. Install fuel pump/solenoid assembly into burner motor housing.
b. Loosely thread (2) mount bolts into the fuel pump housing; do not tighten at this time.
c. Using a 7/16" open end wrench, connect and tighten the fuel nozzle tube B-nut.
d. Using a 9/16" open end wrench, connect and tighten the fuel line B-nut at the fuel pump.
e. Using a ½" open end wrench, tighten the (2) fuel pump mounting bolts.
f. Using a 9/16" open end wrench, connect and tighten the fuel in-line at the fuel water strainer housing.
g. Connect the solenoid electrical plug.
h. Connect power cord to power supply outlet.
i. Perform operations and leak checks.
END OF TASK
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
0014-8
0014
DHS Systems LLC