Reeves G2 series Operation Manual page 54

Operation & Maintenance w/IPB
ITEM CONDITION/INDICATION
12. No Hot Water.
(Cont)
Injector Assy (G2-I and
G2S-I Only).
13. No Clicking Sound when
bypass lever is in the ON
position.
14. Clicking Sound without
Suction of Decon
Solution.
15. Decon Solution Tank.
16.
Decon solution will not
siphon.
END OF TASK
END OF WORK PACKAGE
Part Number: 1006375
This document contains information proprietary to DHS Systems LLC and is intended solely for use by its customers. No portion of this document may be reproduced
for release to a third party without written consent of DHS Systems LLC.
G2 Series Decontamination Water Heater
Table 1. Operator Troubleshooting – Mechanical (Cont).
POSSIBLE MALFUNCTION
No heat or flame.
Water flow rate exceeds rated
service flow of injector.
Operating pressure exceeds
maximum limit.
Suction tube or suction tube
fitting cracked and leaking.
Clogged Suction Tube Filter.
Check valve leaking.
Check Valve Leaking.
Solution pickup is not
completely submerged.
Solution strainer obstructed.
Solution hose is cut,
obstructed or kinked.
Bypass lever is OFF.
Check the fuel pump.
A) Inspect the fuel pump coupler for
wear (should have 1/8" end play).
B) Open the bleeder valve:
1. If fuel flows freely, fuel pump
2. If low or no fuel present from
3. Reset fuel pressure to 140
Contact Reeves EMS
Reduce flow rate.
Install a pressure reducer valve.
Replace as required.
Replace and / or clean as required.
Clean and replace as required.
Check seat area on suction tube
fitting.
Check valve and seal must fit loose in
the suction tube fitting.
Check and submerge if necessary.
Inspect, clean and or replace.
Inspect, clean and or replace.
Turn bypass lever to the ON position.
0010-8
CORRECTIVE ACTION
may not be turning at correct
RPM or fuel pump may be
defective.
bleeder valve, check for
vacuum leaks between the
fuel pump and the fuel tank.
PSI.
DHS Systems LLC
0010