E-Stop/Shutdown Switch - Install/Remove; Joystick Assembly - Install/Remove - JLG 15MVL Series Service Maintenance Manual

SECTION 4 - CONTROL COMPONENTS

E-Stop/ShutDown Switch - Install/Remove

1
Platform Console - E-Stop Switch Installation
1. Loosen Switch Set Screw
2. Turn Switch 90°
3. Pull Spring-Loaded Release
Lever Out
4. Remove Barrel Assembly
Note: (a) Use a small straight blade screwdriver to extend the
spring-loaded retainer hooks (6) out and release the switch
from the body.
4-20
2
3
5
4
6
7
5. Barrel Seal
6. Switch to Body Retainer
Hooks (a)
7. Switch Retainer Slots
– JLG Lift –

Joystick Assembly - Install/Remove

1
2
3
4
Platform Console - Joystick Installation
1. Joystick Assembly
2. Attach Screws (Qty.-4)
3. Nylon Washers (Qty.-4)
Note: (a) Remove the console mounting bracket.
(b) Remove the key switch and e-stop switch to remove
joystick assembly through access hole in bottom of con-
sole.
5
4. Rubber Boot/Gasket
5. Install/Remove through the
Access Hole in Bottom of
Housing. (a) (b)
3121231