Codes (200 - 299) Platform Control Console - Fault Condition - JLG 15MVL Series Service Maintenance Manual

Codes (200 - 299) Platform Control Console - Fault Condition

Check For These Obvious Conditions First:
• Damage to Platform Control Console wiring harness.
• Secure harness connections from Platform Control Console to Platform Junction Box to Ground Control Module.
• Confirm that the static ground strap attached under base frame is secure and undamaged.
Table 6-41. Code (200 - 299) Platform Control Console - Fault Condition
STEP
1. Recycle machine power 5 times allowing a 10 second interval between
each power recycle. Does fault clear?
2. Which 200 code number is displaying?
3. Remove the 9 pin Platform Control Module connector from the side of the
Platform Junction Box and the P4 connector at the Ground Control Mod-
ule. Check continuity from the P4 connector, pin-5 to Junction Box pin-3
and P4, pin-9 to Junction Box pin-4.
Is there continuity on these wires?
4. Perform the Joystick Calibration Procedure in Section 4.5 of this Service
Manual. Does this clear the fault code?
3121231
ACTION
– JLG Lift –
SECTION 6 - TROUBLESHOOTING
SPEC YES
— Done
Code - 200/207/213 Go to Step 3
Code - 202/205/206 Go to Step 4
— Replace
Platform
Control Module
— Done
NO
Go to Step 2
Replace
Platform
Control Module
Repair or Replace
Wiring
Replace
Platform
Control Module
6-37