Table of Contents
Advertisement
SECTION 4 - CONTROL COMPONENTS
Platform Control Console Installation
The platform control console is located in the platform and
mounted on the right side platform rail.
For removal see below, for servicing information see Sec-
tion 4.7, Platform Control Console - Service Procedures.
Platform Control Console - Installation
1. Console Mounting Bracket and Attach Pin
2. Platform Control Console
3. Platform Console to Junction Box Harness (a)
Note: (a) The other end of this harness is plugged into the plat-
form junction box mounted to the mast behind the platform
decal board. From the console the harness is tie strapped
to the platform rail, and run inside the mast through a large
hole in the mast to the platform junction box.
4-4
Horn Installation
1
1. Horn Assembly
Note: See Figure 4-2. for wiring connection instructions.
Alarm Installation
1
1. Alarm Assembly
Note: See Figure 4-2. for wiring connection instructions.
– JLG Lift –
2
Horn Installation
2. Attach Screws/Washers
2
Alarm Installation
2. Attach Screws/Washers
3121231
Advertisement
Chapters
Table of Contents
Troubleshooting
