Hub Disassembly - JLG 15MVL Series Service Maintenance Manual

Hub - Disassembly
1. Remove Main Wheel Bearing (G14).
NOTE: This part is held in the hub with a press fit. To
remove have the hub setting seal side up. Use a
plate or rod with a large enough diameter push in the
inner race of the bearing. Apply force to the push the
bearing out. This bearing will need to be replaced
upon reassembly.
3121231

Hub Disassembly

2. Remove main Lip Seal (G16).
NOTE: This Lip Seal (G16) is also held in with a press fit.
Remove the Lip Seal only if the hub or seal needs to
be replaced. The Lip Seal will most likely become
damaged during removal. Try not to damage the hub
bore.
– JLG Lift –
SECTION 3 - BASE COMPONENTS
3-11