JLG 15MVL Series Service Maintenance Manual page 98

SECTION 5 - MAST COMPONENTS
Tool Use - In-Line Style Fittings (continued)
Step 4. Gently push hose assembly into coupling
body (see directional arrow).
Step 5. Maintaining slight pressure on the hose
assembly, actuate the tool (see arrow).
Step 6. Release the tool and pull on hose assembly
to complete disconnection.
5-8
Tool Use - Angled Style Fittings
Step 1. Prior to disconnection, ensure that system
is not under pressure.
Step 2. Pull on hose assembly to create a gap
between the dust boot and hose fitting
shoulder.
Step 3. Insert the disconnect tool in the gap created
between the dust boot and hose fitting
shoulder.
– JLG Lift – 3121231