SECTION 5 - MAST COMPONENTS
5.12 MAST - 14 FT. HEIGHT LIMITING
SWITCH -15MSP (OPTION)
Ground Control Module Programming settings required:
• Set Ancillary 2 POL to HIGH (Up Arrow)
Location of Proximity Switch and Target
(Right side of mast from rear)
1. Proximity Switch
5-30
2. Target Plate
– JLG Lift –
Proximity Switch Installation
1. Mounting Screws, Nuts
and Washers
2. Switch Shim
NOTE: (a) Proximity switch wiring is routed through hole in
the mast connect support to main harness "Aux 2
Input" connector (orange/red 49-6, black 13),
located under center rear cover on the left side of
the pump/motor.
Target Plate Installation
1. Target Plate
NOTE: (a) Secure to mast using existing holes.
3. Proximity Switch
4. Harness Connector (a)
2. Mounting Screws and
Washers (a)
3121231