Error Messages - Xerox WorkCentre PE120 Service Manual

6.9 Error Messages

The front panel displays the printer's status or error messages. Refer to the list below for an explanation of these
messages and how to clear problems.
MP TRAY JAM [DOOR OPEN]
A paper jam has occurred in the bypass feeder or the media has been improperly fed.
Solution: Clear the paper jam. Load paper in the bypass feeder correctly.
Cancel ? 1. Yes 2. No
While storing the document in memory the memory has become full.
Solution: To cancel the fax job, press the '1' button to accept "Yes." If you want to send the pages that were
stored press the '2' button to accept "No." This will send ONLY the pages stored. The remaining pages should
be sent later when more memory becomes available.
[COMM. Error]
The multi-function printer has a communication problem.
Solution:Ask the sender to try again.
Low Heat Error / Open Heat Error
There is a problem in the fuser unit.
Solution: Check thermostat, thermister contact point & Heating Lamp.
[Over Heat]
The printer has overheated.
Solution: The system will automatically return to standby mode when it cools down to a normal operating
temperature. If this error persists, check the Fuser assembly and wiring.
Delayed Function Full
The delayed fax job list or memory space is full.
Solution: Cancel any unnecessary delayed fax jobs.
Document Jam
The loaded document has jammed in the Automatic Document Feeder (ADF).
Solution: Clear the document jam.
[Door Open]
The front or rear cover is not securely latched.
Solution: Close the cover until it locks into place.
Service Manual
Alignment and Adjustments
6-15