Servicing; Scanner Calibration; Incidents; Error Messages - Xerox WorkCentre 220 User Manual

Maintenance
For guaranteed performance of your terminal, some maintenance work (replacing the fusing unit
and the transfer roll) has to be done on the printer approximately every 50,000 printed pages.
Please contact your supplier for this operation.
You can perform this operation when the quality of photocopied documents is no longer
satisfactory.
Confirm your choice by pressing the OK key.
I
NCIDENTS

Error messages

If the printer has one of the problems described below, the signal "On" flashes red, and you can't
use your machine temporarily. The corresponding message is displayed on the screen.
Message
CHANGE TONER
<OK> TO CONFIRM
CHANGE DRUM
<OK> TO CONFIRM
ILLEGIBLE
CHANGE SIDE
CLOSE FRONT COVE
DRUM NEAR END
TONER NEAR END
S
ERVICING
S
CANNER CALIBRATION
Replace the toner cartridge.
Proceed as indicated Replacing the toner cartridge, page 6-2.
Replace the drum cartridge.
Proceed as indicated Replacing the drum cartridge, page 6-9.
Insert your chip card the right way up.
Close the front cover of the printer.
The drum is nearly worn out (10% use left).
The toner cartridge is nearly worn out (10% capacity left).
6-17
80 OK - ADVANCED FCT / CALIBRATION
Action