Drive Assembly; Cover Mid Front - Xerox WorkCentre PE120 Service Manual

5.16 Drive Assembly

(PL 8.2)
1. First remove:
a. Rear cover, see page 5-2.
b.
Side cover, see page 5-3.
c.
Controller shield, see page 5-11.
2.
Remove 5 screws securing the drive assembly.
Drive Ass'y

5.17 Cover Mid Front

(PL 8.1.19)
1.
First remove:
a.
Rear cover, see page 5-2.
b.
Side cover, see page 5-3.
c. Middle cover, see page 5-10.
2. Remove 4 screws securing the cover mid front and
release 2 clips from the center as shown.
3. Take out the drive assembly then unplug the
connector from the motor board.
Drive Ass'y
Caution
The 6 screw holes have numbers stamped into the
base plate, when reinstalling the drive assembly the
screws must be tightened in the order they are
numbered. Screw 6 is fitted with the controller
shield.
Cover Mid Front
Service Manual
Disassembly
clips
5-17