Tech Mode; Entering Tech Mode; Tech Mode Menu; Data Setup - Xerox WorkCentre PE120 Service Manual

Alignment and Adjustments

6.4 Tech Mode

In Tech (service) Mode the technician can check the system and perform various tests to help with diagnosing
problems. While in Tech Mode the system still performs all normal operations.

6.4.1 Entering Tech Mode

1.
Press the following buttons in order: Menu, #, 1, 9, 3, 4
2. The LCD displays 'TECH' and the system is now in Tech Mode.

6.4.2 Tech Mode Menu

6.4.3 Data Setup

SEND LEVEL:
This sets the fax send level for the transmission signal. Typically, the transmission (send) level should be under
-12 dBm.
Note
The send fax level is set for optimal performance at the factory. Do not change this setting unless it is
needed for troubleshooting.
DIAL MODE:
This function chooses the dialing method for Tone or Pulse. The default is Tone.
MODEM SPEED
This sets the modem speed.
When the fax establishes communication with a remote set, the value of the maximum modem speed is
checked for both transmitter and receiver. The lowest value is used. It is best set to the default setting of
33.6Kbps.
6-8 WorkCentre PE 120/120i