Pick Up Assembly - Xerox WorkCentre PE120 Service Manual

Disassembly

5.20 Pick Up Assembly

(PL 8.7)
1. First remove:
a. Rear cover, see page 5-2.
b.
Left and right side covers, see page 5-3.
c.
Front cover, see page 5-4
d. Scanner assembly, see page 5-4.
e. Middle cover, see page 5-10.
f.
Controller shield, see page 5-11.
g.
Engine shield, see page 5-12
h. Drive assembly, see page 5-17.
i.
Feed assembly, see page 5-18
2.
Remove the pick up gear assembly.
Pick up Gear Ass'y
3.
Take out the pick up assembly as shown.
Bush
1
2
5-20 WorkCentre PE 120/120i
4. Remove the 2 screws securing the manual solenoid
and pick up solenoid.
Pick Up Solenoid
Manual Solenoid
Replacement
1. To replace the pick up roller, slide the stopper
securing the sponge roller to the right and then turn
the sponge roller to remove from the shaft.
Sponge Roller
Note
It is not necessary to disassemble the system to
replace the MP or Main cassette pick rollers.
Stopper
Shaft