Panasonic KX-TVS95 Installation Manual page 98

4.3 KX-TD500 PROGRAMMING FOR DIGITAL INTEGRATION
7.
Connect the jack assigned in Step 4 to the VPS.
8.
Connect your personal computer to the VPS and start your communication software
(i.e., HyperTerminal, Procomm Plus, Smartcom...).
Communication Parameters: 9600, 8 Bit, None, 1
9.
Disconnect the power from the VPS and set the DIP Switch to position 5.
Only perform this step when initially setting up the system.
CAUTION
Setting the DIP Switch to position 5 will default the Voice Processing System,
resulting in a loss of all user programming and voice messages (except User 1 and
User 2 prompts).
10.
Plug in and power up the VPS and wait approximately 2.5 min while the system
initializes.
Before starting the VPS, make sure all installation and line connections have been
done as described in Section 2 INSTALLATION.
The calls to the VPS can be processed after the Power Indicator stops flashing.
After turning the power on, the system starts up in the following sequence:
•
•
•
98 Installation Manual
Screen output:
The Power Indicator light goes on.
The Power Indicator light begins to flash.
"Checking Flash Memory Cards" is displayed on the screen.