Table of Contents
Advertisement
Subscriber Tutorial
28.
a)
The current setting plays. Press [1] to change the setting (enable or disable).
b)
Confirm the entry is correct and Press [2] to accept it.
Message Notification
29.
a)
The current setting plays. Press [1] to change the setting (enable or disable).
If the Message Notification is enabled, go to Step 29b below.
b)
Press [1], [2], [3], [4], or [5] to choose the desired Beeper Callback Number
Entry Mode.
•
•
•
•
•
c)
Confirm the entry is correct and Press [6] to accept it.
d)
The current setting of MWL Notification for Unreceived Message plays. Press
[1] to change the setting (enable or disable).
e)
Confirm the entry is correct and Press [2] to accept it.
f)
The current setting of Device Notification for Unreceived Message plays.
Press [1] to change the setting (enable or disable).
g)
Confirm the entry is correct and Press [2] to accept it. Return to Step 29a
above.
External Message Delivery
30.
a)
The current setting plays. Press [1] to change the setting (enable or disable).
If the External Message Delivery is enabled, set the prompt mode for
receiving External Delivery Messages (go to Step 30b below).
b)
The current prompt mode plays. Press [1], [2], [3], or [4] to choose the
desired mode.
•
•
•
•
c)
Confirm the entry is correct and Press [5] to accept it. Return to Step 30a
above.
C3 SETTING COS (CLASS OF SERVICE) PARAMETERS
[1] Caller Select Mode
[2] Without message mode
[3] Before message recording mode
[4] After message recording mode
[5] Disable All Entry Mode (Caller cannot access beeper)
[1] System Prompt
[2] User 1 Prompt
[3] User 2 Prompt
[4] Selective Prompt
Installation Manual
349
Advertisement
Table of Contents
Troubleshooting
