Table of Contents
Advertisement
5.4.3
Operator's Parameters
If you enable operator service, you must set the following parameters: Operator's Extension
and Mailbox Number, Coverage Modes, and Message Repeat Cycle.
Operator 1:
The default is set at "0" which coincides with the operator of the PBX. When a caller
tries to leave a message to the Operator 1, the message will automatically go to the
General Delivery Mailbox (GDM) by default.
Operators 2 and 3:
For KX-TDA/TAW series, KX-TD816, KX-TD1232, KX-TD500 and KX-TA1232,
Operators 2 and 3 can be assigned to a floating number that is assigned to a ring
group.
Return to Program-Service Setting-Auto. Attn. Setting Menu:
Enter The Number : = 2
Program - Service Setting - Auto. Attn. Setting - Operator's Parameters Menu
SELECT ITEM AND PRESS KEY
SELECT ITEM AND PRESS KEY
Enter the data using the table below as a guide. The table below is for Operator 1 as an
example. Please refer to it for Operators 2 and 3.
Table 5-6
Description
Operator
Service
1. Day Mode
2. Night Mode
3. Lunch Mode
4. Break Mode
1. Operator 1
2. Operator 2
3. Operator 3
Value Range
(Default)
1. Disable
2. Enable
(Enable)
5.4 AUTOMATED ATTENDANT PARAMETERS
Description/Function
Enables or disables the Operator Service feature.
Note
All non-touchtone input calls in Automated
Attendant Service will be transferred to the
General Delivery Mailbox when the Operator
Service is disabled.
Installation Manual
163
Advertisement
Table of Contents
Troubleshooting
