Panasonic KX-TVS95 Installation Manual page 312

B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Table B-29
Parameter
Message
Manager
Access
from
Telephone
Default
Password
for
Subscriber
312 Installation Manual
Value Range
(Default)
1: Disable Enables/disables access to the VPS from the Message
2: Enable Manager's telephone.
(Disable)
Note
The System Administrator will be asked to set a
Message Manager password if both of the following
conditions are met:
•
•
The password must be entered twice for verification.
1: No Defines whether or not the VPS sets a default password to
2: Yes Subscribers' Mailboxes when they are created. The default
(No) password depends on the setting in the following "Default
Password Format" parameter.
Note
Even if this parameter is changed from "No" to "Yes", a
new default password will not be set to already-created
mailboxes. Pre-assigned passwords remain valid.
The password can be changed in the following ways:
•
•
Description/Function
The System Administrator changes this
parameter from "Disable" to "Enable".
The Message Manager password has not been
set previously.
Subscribers can change or clear the default
password for their mailboxes within Subscriber
Service.
The System Administrator or the System Manager
can reset the password.
After the password is reset, the conditions will be
as follows:
<Subscribers' Mailboxes>
If this parameter is set to "Yes", the password will
be initialized to the default password. If this
parameter is set to "No", the password will be
cleared.
<Managers' Mailboxes>
The password is initialized to "No password".
When the System Manager's password is reset,
the "System Manager Access from Telephone"
parameter will automatically change to "Disable".
When the Message Manager's password is reset,
the "Message Manager Access from Telephone"
parameter will automatically change to "Disable".