Panasonic KX-TVS95 Installation Manual page 315

Table B-31
Parameter
Number of
Digits to
Access
Outside Line
Call Transfer
No Answer
Time
Outgoing Call
No Answer
Time
Pause Time
B6 SYSTEM ADMINISTRATION—SYSTEM PARAMETER SETTINGS
Value Range
(Default)
0-8 digits Specifies the number of digits necessary to access an
(1) outside (CO) line.
Example:
If the PBX requires callers to dial "9" to access an
outside (CO) line, this parameter should be set as "1".
This enables the system to recognize that an outgoing
call setup sequence is completed once the initial "9" has
been dialed (9-123-4567). The full sequence is
therefore: 9-(outgoing call setup sequence)-123-4567.
The VPS can discriminate between local and long
distance calls and can report outgoing calls and calling
times for billing purposes on periodic port usage
reports.
10-60 s Specifies the length of time that the VPS must wait
(20) before retrieving the transferred call when there is no
answer at the destination extension.
Note
Make sure that the duration of Call Transfer No
Answer Time is longer than the duration of Call
Forwarding No Answer Time at the PBX.
Otherwise, the PBX may forward the call
(transferred by the VPS) immediately to its
destination without leaving enough time to answer
the call.
10-90 s Specifies the length of time that the VPS must wait
(30) before concluding that there is no answer at the outside
number called.
1-9 s Specifies the pause time between dialed digits.
(2)
Description/Function
Installation Manual 315