Circuit Condition Display (Lmon); Touchtone Information Display (Putd) - Panasonic KX-TVS95 Installation Manual

7.2 UTILITY COMMANDS

7.2.18 Circuit Condition Display (LMON)

Use the LMON command to display the circuit condition every 1.5 s. To turn off this command,
enter [\].
The following circuit conditions may be displayed.
"Ready"
"Incoming Call"
"Outgoing Call"
"DSP Reset"
"PT connect"
"Error"
$ LMON
No.:

7.2.19 Touchtone Information Display (PUTD)

Use the PUTD command to display the touchtones the VPS receives and sends.
In addition to the touchtones, the following will be displayed—the Incoming Call Service (Voice
Mail, Automated Attendant, Custom, and Interview) entered by the caller and the time periods
that the ports are enabled.
Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The default
setting of this mode for all ports is "OFF".
$ PUTD
Target Port : **
Don't leave enabled after troubleshooting.
$
To change the mode from "PUTD" to "OFF", Type PUTD again.
$ PUTD
Target Port : 00
Don't leave enabled after troubleshooting.
$
Note
"*" means "enable" for the port. "0" means "disable" for the port.
To set the mode for only 1 port, Type PUTD and the port number.
$ PUTD 1
Target Port : 0*
Don't leave enabled after troubleshooting.
$
202 Installation Manual
: Possible to serve
: Processing arrival service
: Processing sending service
: Processing DSP reset disposition
: Processing PT connect disposition
: DSP Card is not loaded
Status
1: Ready
2: Ready