Table of Contents
Advertisement
Table A-1
FEATURE
Calling a Beeper
allows a subscriber to be notified by a beeper
when he has message(s). If the beeper has a
display, it is possible to send to it a callback
number. The callback number can be
recorded when a caller leaves a message. If
the caller does not leave a callback number,
the System Callback No., or the caller's
number if it is received through a telephone
company's Caller ID service, will be sent
instead.
To utilize this feature, follow the procedure
below.
1)
Go to the System Administration Top Menu,
and type 1-2 (Program-Class of Service) and
COS No.(1-63).
Select "Yes" in the Authorization for Message
Notification parameter. Make 1 selection from
the available options in the Beeper Callback
No. Entry Mode parameter.
2)
From the System Administration Top Menu,
type 1-1-1-Mailbox No.-Y-2-Device No.(1-3)
(Program-Mailbox Setting-Enter/Edit-Mailbox
No. Entry-Do you want to edit this mailbox?-
Notification Setting-Device No. Entry).
For the Dial Number parameter: enter your
PBX's line access code before the beeper
number for dialing outward; enter an X after
the beeper number. (The X is for the caller to
enter his number as the callback number
which will later appear on your beeper.)
Finally, select "Beeper" in the Type of Device
parameter.
DESCRIPTION
A1 SYSTEM FEATURES
REFERENCES
•
See "Dial Number" and "Type
of Device" in Table B-4 in B2
SYSTEM
ADMINISTRATION—
MAILBOXES.
•
See "Authorization for
Message Notification" and
"Beeper Callback No. Entry
Mode" in Table B-6 and Table
B-7 in B3 SYSTEM
ADMINISTRATION—
SETTING COS (CLASS OF
SERVICE) PARAMETERS.
•
See "System Callback No." in
Table B-32 in B6.8 Other
Parameters.
•
See C3 SETTING COS
(CLASS OF SERVICE)
PARAMETERS.
Installation Manual
225
Advertisement
Table of Contents
Troubleshooting
