Panasonic KX-TVS95 Installation Manual page 330

B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Table B-44
Parameter
Call Waiting
Sequence
Release
Sequence
for Call
Waiting
Inband Signaling Parameters
Use these parameters if the PBX sends touchtones to the VPS to indicate the state of a call
(busy, answered, disconnected, etc.). The integration mode must be set to "Inband". If PBX
type is set to a KX-T series telephone system, the Inband Signaling parameters will
automatically default to the proper codes.
To access the menu for Inband Signaling Parameters, follow the menu path as
shown:
System Administration Top Menu-1-6-3-2
The following parameters can be programmed using "0-9", " ", "#", and "A-D".
Table B-45
Parameter
Ringback
Busy
Reorder
DND
Answer
Forward to
VM Ringing
Forward to
VM Busy
330 Installation Manual
Value Range
(Default)
The VPS carries out this sequence when performing call
(1)
waiting if the extension being called is busy.
The VPS performs this sequence to release call waiting.
(F)
Value Range
(Default)
Indicates "Ringback Tone". Sent to the VPS when the
(1)
extension dialed is ringing.
Indicates "Busy Tone". Sent to the VPS when the
(2)
extension dialed is busy.
Indicates "Reorder Tone". Sent to the VPS when an
(3) invalid extension number is dialed or when inadvertently
connected to another VPS.
Indicates "Do Not Disturb Tone". Sent to the VPS if the
(4)
dialed extension has the Do Not Disturb feature enabled.
Sent to the VPS when the called extension answers the
(5)
call.
Sent to the VPS if the called extension is forwarded to a
(6) voice mail port and that voice mail port is available to
accept the call.
Sent to the VPS if the called extension is forwarded to a
(7) voice mail port and that voice mail port is not available to
accept the call.
Description/Function
Description/Function