Table of Contents
Advertisement
From Mailbox Setting Menu:
Enter The Number : = 1
Enter the Mailbox number: =
Program - Mailbox Setting - Enter/Edit Menu
1. Mailbox Setting
2. Notification Setting
3. Remote Call FWD to CO
Enter The Number : = 2
Program - Mailbox Setting - Enter/Edit - Notification Setting
1. 1st Device
2. 2nd Device
3. 3rd Device
Enter The Number : =
Enter the data using the following table as a guide.
Table 5-8
Parameter
Dial Number
Type of
Device
Value Range
(Default)
Up to 32 digits
Assigns a telephone or beeper number to Device 1, 2,
consisting of 1-9,
or 3. The subscriber can also specify the dial number
from his telephone.
0, , #
P, T, M, X
P: Pause
(None)
T: Dial Tone Detection
M: Dial Mode Switching Code (Touchtone to Pulse, or
Pulse to Touchtone)
X: Callback Number Entry Code
1-9, 0, , #: Dial Codes
Note
Notice
1. Telephone
Specifies the device to receive notification. This is
automatically set to "Beeper" when "X" is used in the
2. Beeper
Dial Number (above). The subscriber can also specify
(Telephone)
the type of device from his telephone.
Description/Function
The callback number entry code "X" must be
included in the number to be called if the Beeper
Callback No. Entry Mode is enabled through COS
and "Type of Device" is set to "Beeper". The proper
number of "Pauses" must be inserted before the
callback entry code.
When the VPS calls to a CO line via a PRI (ISDN
Primary Rate Access Interface) card of a
Panasonic PBX, please be sure to add "#" after the
telephone number (1112223333 in the example
here):
Example: 9P1112223333#PP123PP456PPX#
Please contact your System Administrator for more
explanation.
5.5 SETTING MAILBOXES
Installation Manual
169
Advertisement
Table of Contents
Troubleshooting
