B7.2 Port Setting - Panasonic KX-TVS95 Installation Manual

B7.2 Port Setting
To access the menu for Port Setting, follow the menu path as shown:
System Administration Top Menu-1-6-2
Port Setting Menu
To access the menu Port Setting Menu for the selected port, follow the menu path
as shown:
System Administration Top Menu-1-6-2-Port No.(1-2)
Note
The maximum number of ports depends on the VPS model.
Table B-40
Parameter
Flash Time
CPC Signal
Disconnect
Time
Dial Mode
B7 SYSTEM ADMINISTRATION—HARDWARE SETTINGS
Value Range
(Default)
1. 100 ms Specifies the length of time the hook switch must be
2. 300 ms pressed before the PBX will recognize it as a flash hook
3. 600 ms signal. See the PBX manual to determine the correct
4. 900 ms value.
(600)
1. None Specifies the minimum time necessary to detect an
2. 6.5 ms interruption in the CPC (Calling Party Control) signal
3. 150 ms received from the PBX. The VPS is able to determine
4. 300 ms that the line has been disconnected when it detects an
5. 450 ms interruption of the CPC signal.
6. 600 ms
(None)
1-8 s Specifies the length of time the line will temporarily be
(2) unavailable after a call has ended.
1. DTMF Specifies the dial mode for DTMF (touchtone) or Pulse.
2. Pulse 10 pps If Pulse is specified, pulse speed (10/20 pps) must be
3. Pulse 20 pps selected.
(DTMF)
Note
Description/Function
This setting only affects outward dialing from the
VPS. The VPS can only receive DTMF (touchtone)
signals.
Installation Manual 325