6-4 Installing and Using Utilities
DOS-based EXPRESSBUILDER with Local Console
This subsection describes the procedures for using the DOS-based EXPRESSBUILDER with local console.
Starting EXPRESSBUILDER
The following procedure instructs you to start EXPRESSBUILDER.
IMPORTANT: Do not remove the EXPRESSBUILDER CD-ROM while
EXPRESSBUILDER is running.
3.
Turn on first the peripheral devices and then the server.
2.
Insert the EXPRESSBUILDER CD-ROM supplied with your server into the CD-ROM drive of your server.
3.
Ensure that the floppy disk drive is empty.
4.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot from the EXPRESSBUILDER. (You may
also turn off and then on again to reboot the server.)
EXPRESSBUILDER boots up displaying the top menu.