Table of Contents
Advertisement
2-4 General Description
1
Front mask
The front mask protects the front face of the chassis.
2
CD-ROM drive
The CD-ROM drive reads data from the inserted CD-ROM.
Each drive is equipped with the following:
•
Open/Close button to eject the tray
•
Access lamp that indicates the disk access status (lights orange while being accessed)
•
Emergency hole to forcibly eject the tray
3
5.25-inch device bay
Backup file device of 5.25-inch width such as DAT drive or Magneto Optical (MO) drive may
be installed in the 5.25-inch device bay.
A CD-ROM drive is factory-installed in the bottom bay.
To install a DVD-RAM drive or internal AIT (IDE), install it in the bottom bay. In this case,
move the CD-ROM drive to the additional slot 1 and connect it as a master drive.
4
Disk access lamp (green)
The disk access lamp lights while the system accesses to an internal hard disk drive. If the
internal hard disk drive is connected to the optional board, this lamp can be lit only when the
LED cable provided with the server is connected.
5
POWER/SLEEP lamp (green)
Lights green when the server is powered on. Blinks green when the system is placed in the
sleep mode.
6
POWER/SLEEP switch
The POWER/SLEEP switch is used to turn the power of the server ON/OFF. If you press this
switch once, the power is turned on with the lamp going on green. If you press the switch
again, the power is turned off.
Some OS settings can provide the function of switching to the power saving (sleep) mode.
Once it is setup as such, if you press the POWER/SLEEP switch once, the system enters
into the power saving mode. If you press the switch again, the system returns to the normal
state. (Depending on installed optional boards, the function cannot be provided.)
7
3.5-inch floppy disk drive
Reads/writes data from/to the 3.5-inch floppy disk inserted.
The floppy disk drive is equipped with the following:
•
Eject button to eject the floppy disk
•
Access lamp that indicates the floppy disk access status
8
USB connectors
The USB connectors are connected with devices accepting the USB interface.
9
Stabilizer
Use the stabilizers to prevent the server from falling down. Close the stabilizers when laying
the server down.
10
Hard disk drive bay
The bay can contain 4 hard disk drives.
11
Release tabs (4 at an end of front mask)
The release tabs are provided to unlock the front mask. Press the tabs to remove the front
mask.
Advertisement
Table of Contents
