Table of Contents
Advertisement
5-32 Installing the Operating System with Express Setup
10.
Select the installing Operating system.
Select "Windows" from the menu.
11.
Select the Windows family.
Select "Microsoft Windows 2000 Server Microsoft Windows 2000 Advanced Server" category.
NOTE: If you select "Skip" at step 8, this menu does not appear.
Go on the step 13.
12.
Next, [Basic Information] wizard appears. Confirm the parameters, modify if necessary, and then click [Next].
After that, click [Next], [Back], or [Help] on the screen to continue. Modify the parameters each time if
necessary.
IMPORTANT:
Reserve the partition to install the OS more than the minimally required size.
If you select "Use Existing Array" at "New/Existing RAID Configuration", the information
included in the first partition (excluding maintenance partition) will all be formatted and deleted. The
information included in the other partition will be retained. In the figure below, describes the
partition which information will be deleted when maintenance partition exists.
You can not re-install the system with the existing partition that is upgraded to Dynamic Disk
remained. Do not select "Use Existing Array" at "New/Existing RAID Configuration".
If "Create New Partition" at "New/Existing RAID Configuration" is selected, do not specify the
value for the partition more than the actual area size.
If you specify other than 4095MB for the "Installing Partition", it is necessary to convert to NTFS.
If "Use Existing Array" at "New/Existing RAID Configuration" is selected but the partition other
than the one to install Windows 2000 does not exist (excluding maintenance partition), Express
Setup will reserve the maximum area of the hard disk drive to install Windows 2000.
First Partition
<Maintenance Partition>
Retained
Second
Third
Fourth
Partition
Partition
Partition
Deleted
Retained
Retained
Advertisement
Table of Contents
