11.
Fix the SATA cable as shown in the figure below.
12.
Connect the SATA cable to the RAID board (SATA).
A label indicating a channel number of destination port is attached to SATA cable. Connect the SATA cable to
the port (connector) having the same number as that of SATA cable.
NOTE:
The figure below shows an example when connecting to the SX4100 Serial-ATA
Disk Array Controller board. The location of connector and assignment of channel numbers
depend on the board. Refer to the manual that comes with your board.
Channel 2
Channel 1
13.
Install the left side cover.
Channel 4
Channel 3
Upgrading Your Server 9-41
Cable clamp
CH1
CH2
CH3
CH4