Table of Contents
Advertisement
5-30 Installing the Operating System with Express Setup
Installing the Windows 2000
Express Setup proceeds the setup by specifying the necessary information on the wizard. You can also save the setup
information created on the wizard in a floppy disk as a setup file.
NOTE: One floppy disk formatted by MS-DOS 1.44MB is necessary to save the setup
information. Please prepare a floppy disk by yourself before the installation.
Using the same setup file you saved and used before allows you to omit specifying the setup information on the wizard.
And if you use a floppy disk which is attached to the optional device such as disk array controller and contains device
driver to install optional mass storage driver while processing the Express Setup, you have to save the setup information
in the setup file. Please prepare one empty floppy disk for setup file in this case, too.
1.
Turn the power of peripheral device on, and then turn on the server.
NOTES:
If you operate installing Windows 2000 with MO device connected, the installation may not be
completed normally. In such case, detach MO device and then re-install the system from the
beginning.
Connect the hard disk drive that OS is not going to be installed after installing OS.
If you create multiple logical drives in your system, refer to "Reinstalling the operation system
when multiple logical drives exist" (Appendix D).
2.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
3.
Press the RESET switch or press Ctrl, Alt, and Delete to reboot the EXPRESSBUILDER. (You may also
turn off and then on again to reboot the server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
4.
Click [Express Setup].
5.
The message, "Do you want to use the parameter file in order to set up the Server or Workstation?", will be
displayed.
If you use the setup parameter file, click [Yes] and if you do not use the setup parameter file, click [No].
Advertisement
Table of Contents
