Nec Expressbuilder; Start Menu - NEC Express5800/320Fa-L User Manual

5-2 Installing and Using Utilities

NEC EXPRESSBUILDER

The NEC EXPRESSBUILDER, integrated setup software, can automatically detect the hardware
connected to an NEC Express5800/ft series machine to advance the processing. The hardware
subject to setup with the NEC EXPRESSBUILDER should have the same configuration as that for
operation.

Start Menu

The NEC EXPRESSBUILDER provides three procedures to start the server as described below. The
menus and items appearing on the screen vary depending on the procedures.
Booting (starting) the server from NEC EXPRESSBUILDER CD-ROM
For the procedure, insert the NEC
EXPRESSBUILDER CD-ROM into the
CD-ROM drive of the NEC Express5800/ft series
and start the NEC Express5800/ft series from the
system in the NEC EXPRESSBUILDER. When
the NEC Express5800/ft series is started by using
this procedure, the NEC EXPRESSBUILDER top
menu shown on the right appears.
Setup the NEC Express5800/ft series from this
menu.
IMPORTANT:
Do not use this CD-ROM on computers other than this server with which it is packaged
(including other NEC Express5800 models). Otherwise, a breakdown may result.
The execution of "Setup" of the menu causes the OS installed previously to be erased. OS
must also be reinstalled.
See "NEC EXPRESSBUILDER Top Menu" for details.
Inserting NEC EXPRESSBUILDER
CD-ROM after Windows startup
The "Master Control Menu" (see figure on the
right) starts automatically after you place the
"NEC EXPRESSBUILDER" in the CD-ROM
drive. A dialog box called "Master Control
Menu" will appear.
For this dialog, see "Master Control Menu"
described later.