Table of Contents
Advertisement
Installation
Install a file device in the following procedure. Explanations are for factory-installed file bay. Explanation specific for
hard disk drive installing kit is also described.
SCSI Device
1.
Provide the proper setting for the device.
See the table below for the settings of the devices which can be installed in the device bay.
Device
SCSI device
*
If the terminator is not connected to the optional internal SCSI cable, set the termination resistance to ON.
IMPORTANT:
2.
See the section "Preparing for Installation and Removal" described earlier to prepare.
3.
Remove the left side cover and front mask as described earlier in this chapter.
4.
Remove all the cables from the factory-installed CD-ROM and floppy disk drives and the devices installed in
the device bay.
5.
Remove the two screws securing the dummy cover of the additional slot 1.
IMPORTANT:
NOTE:
If you are going to install the hard disk drive device bay conversion kit, remove
the dummy cover from the additional slot 2.
Setting
Termination resistance: OFF*
SCSI ID for the device you are installing must be unique.
Keep the removed dummy cover for future use.
Upgrading Your Server 9-31
Advertisement
Table of Contents
