Table of Contents
Advertisement
4.
Specify "Complete memory dump" and modify [Dump file:] in the [Write debugging information] group box.
e.g. Write the debug information in D drive write the file name "MEMORY.DMP".
D:\MEMORY.DMP
5.
Click [Settings] on the [Performance] group box.
The [Performance Options] window appears.
6.
Click [Advanced] tab on the [Performance Options] window.
7.
Click [Change] on the [Virtual memory] group box.
8.
Modify [Initial Size] in the [Paging file size for selected drive] box to the value larger than [Recommended],
and click [Set].
IMPORTANT:
The above-mentioned paging file size is recommended for collecting debug information (memory
dump). The paging file with initial size large enough to store the dump file in the boot drive is
required.
Correct debug information might not be able to be collected due to virtual memory shortage when
the paging file is insufficient, so set the paging file with a size big enough for the entire system.
For more information on the "Recommended" value, see "Partition Size to be Created" described
earlier.
In case the memory is expanded, re-specify the paging file to suit the new memory size.
Test the dump switch before any trouble occurs.
9.
Click [OK].
Restart the system if prompted to do so.
Installing the Operating System with Express Setup 5-19
Advertisement
Table of Contents
