Table of Contents
Advertisement
7.
Select the proper SCSI Adapter and press Enter.
– LSI MEGARAID Products for Windows 2000 (When the SecuRAID 114 board is installed.)
– Adaptec Ultra320 SCSI Cards (Win2000) (When the Adaptec 29320 board is installed.)
– Promise FastTrak S150 SX4100(tm) Controller-Intel x86 platform (When the SX4100 board is installed.)
– Adaptec Embedded Serial ATA HostRAID Driver For Windows 2000/XP/2003 (When HostRAID is
installed.)
Continue performing tasks according to the subsequent messages that appear.
After installation is completed, be sure to execute the tasks described in "Driver Installation and Advanced Settings"
and "Updating the System" of this manual.
Reinstallation to Multiple Logical Drives
This subsection describes the procedure for reinstalling the operation system if the multiple logical drives exist.
Before Re-installing the Operation System
Be sure to make backup copies before re-installing the operation system just in case.
Re-installing the Operation System
1.
Start the clean installation following the procedure described in this manual.
2.
Specify the partition in which you want to install the operating system when the following message appears:
The following list shows the existing partitions and
unpartitioned space on this computer.
Use the UP and DOWN ARROW keys to select an item in the list.
*
Cannot modify the drive letter of your system or boot volume. Confirm the proper drive letter is
assigned and then, continue the setup.
3.
Continue the clean installation again following the procedure described earlier in this chapter.
The drive letter of the re-installed system may differ from the one of the previous system. If you need to
modify the drive letter, modify it according to the "Procedure for Modifying the Drive Letter".
Installing Windows 2000 F-7
Advertisement
Table of Contents
