Table of Contents
Advertisement
D-4 Installing Windows Server 2003 x64 Editions
INSTALLING WINDOWS SERVER 2003 X64 EDITIONS
Preparations for Installation
EXPRESSBUILDER CD-ROM
Microsoft Windows Server 2003 Standard x64 Edition (CD-ROM)
User's Guide
Getting Started
Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER
Creating "Windows Server 2003 x64 Edition OEM-DISK for
EXPRESSBUILDER"
Before installing, create Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER.
NOTE:
If you have already "Windows Server 2003 x64 Edition OEM-DISK for
EXPRESSBUILDER" for the server which you are going to install Windows Server 2003
x64 Edition, you do not need to create it again.
You can create Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER with the following two
procedures.
Create from the menu which appears when running this server with EXPRESSBUILDER.
If you have only this server to create Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER,
use this procedure.
If Windows Server 2003 or Windows 2000 can be operated on another server, you can use the other procedure
described later.
Follow the steps below.
1.
Prepare one 3.5-inch floppy disk.
2.
Turn on your server.
3.
Insert the EXPRESSBUILDER CD-ROM into the CD-ROM drive of the server.
4.
Press the RESET switch or press Ctrl + Alt + Delete to reboot the server .(You may also turn off and then on
again to reboot the server.)
The system will boot from the CD-ROM and EXPRESSBUILDER starts.
5.
Select [Create Support Disk] from [Tools].
6.
Select [Windows Server 2003 x64 Edition OEM-DISK for EXPRESSBUILDER] from [Create Support Disk]
menu.
Advertisement
Table of Contents
