Table of Contents
Advertisement
9-42 Upgrading Your Server
14.
Install the hot-plug SATA hard disk drives in the HDD cage.
Fully open the lever of the hard disk drive and insert the drive into the HDD cage until it hits the depth of
HDD cage.
After the hard disk drive is fully inserted into the cage, close the lever to fix the drive. (A click occurs when it
is locked.)
IMPORTANT:
service representative for available hard disk drive.
NOTE:
Make sure of the orientation of the hard disk drive tray before inserting the drive.
See the figure below. Also make sure that the hooks of the hard disk drive are engaged with
the frame of the HDD cage.
NOTE:
The slots of the HDD cage contain trays without hard disk drive. To install the
hard disk drive, first remove the tray according to the removal procedure described later.
Install a hard disk drive tray to the vacant slot of the cage to keep the cooling effect of the
server.
To remove the hard disk drive carrier, push the green tab on the lever and open the lever toward you until it stops. Then,
the hard disk drive tray is unlocked.
Securely hold the tray and the lever and insert the tray straight into the HDD cage.
IMPORTANT:
destroys the logical disk. Remove or replace the hard disk drive one by one.
Removal
The HDD cage can be removed in the reverse order of the installation.
Remote Management Card (RMC)
Remote Management card (RMC) is an optional expansion card that includes the Baseboard Management Controller
(BMC) based on IPMI 1.5.
The RMC performs the following:
Monitors power supply unit.
Monitors temperature, voltage and cooling fans
Remote server management (e.g., resetting the server, power on/off, monitoring System Event Log (SEL))
through networks (LAN or WAN) by DianaScope.
Use the hard disk drive that we do not authorize. Consult with your
2
Removing more than one hard disk drive while the server is powered on
1
Advertisement
Table of Contents
