Table of Contents
Advertisement
The system does not restart automatically when a stop error occurs, though the system is adjusted to
automatically restarting:
→ When the system does not restart automatically, restart it manually.
The system restarts automatically when a stop error occurs, though the system is NOT adjusted to automatically
restarting:
→ There is no problem about this issue.
Check the System Event Log to confirm that STOP error occurred.
Cannot turn the power OFF at the blue screen:
→ If you want to turn off the power at the blue screen, execute forced shutdown (forced shutdown:
continue to press POWER/SLEEP switch for 4 seconds). The power will not be turned off if you press
the switch for less than 3 seconds.
The PXE boot (network boot) fails or the server is not found on the network:
8 Is the cable connected properly?
→ Connect the proper cable to the network port on the rear of the Server. In addition, make sure that the
used cable conforms to the network interface standard.
8 Is BIOS configuration correct?
→ The internal LAN controller may be disabled with the BIOS Setup utility of the server. Check the
setting with the BIOS setup utility.
8 Have the protocol and service already configured?
→ Install the distinctive network driver for the server. Make sure that the protocol, such as TCP/IP, and
services are properly specified.
8 Is the transfer speed correct?
→ Open the network property dialog box in control panel to specify the link speed and duplex value the
same as the value specified for HUB.
Troubleshooting 8-17
Advertisement
Table of Contents
