Table of Contents
Advertisement
6.
"Note" will be displayed. Read the instruction carefully and click [Confirm].
7.
Notes and restrictions are displayed.
Read the messages carefully and click [Confirm].
NOTE: If some oparating system has been installed on the hard disk drive already, the
message which asks if you continue the installation appears.
If you wish to continue the installation, click [Continue].
8.
If you select "Yes" at step 5, place a floppy disk into the floppy disk drive mounted on the server.
If not, go on the next step.
NOTE: If you set the floppy disk at this step, do not remove the floppy disk from the
server until the message as removing the floppy disk appears.
[Using the existing Configuration Disk]
The parameters files in the floppy disk is listed in dialogue-box.
1) Select a parameters file to use in the Express Setup.
After the parameters file is specified, the message "Do you want to review or modify the Setup File
parameters?" appears.
2) If you want to modify or confirm the parameters file, click [Review]. If not, click [Skip].
Click [Review] → Go on the next step.
Click [Skip] → Go on the step 10.
[Using a blank disk]
1) Click the box under [Setup File Name: (A)] or press A.
The dialog box appears.
2) Input the file name and click [Use].
9.
Confirm or modify the parameters of disk array configuration.
[Configure RAID] screen appears. Confirm the specification, modify if necessary, and then click [OK].
NOTE: Choose RAID0 when you install it in one hard disk drive.
When the dialogue-box is closed, the Express setup automatically performs the RAID configuration, creating
Maintenance partition and installing several utilities.
Installing the Operating System with Express Setup 5-31
Advertisement
Table of Contents
