NOTE:
The handles are only used to slide the server in and out of the rack. DO NOT use
these handles to carry the server.
Attach the handles (A in figure 1) to the rack mounting frame with two screws (B in figure 1).
Installing the Rack Mounting Frame on the Server
Install the rack mounting frame on the server as follows:
1. Remove the right side door.
2. Remove the front panel.
3. Install the rack mounting frame (A) on the server (B) as shown in figure 4 below.
Figure 4: Installing the rack mounting frame on the server
4. Slide the rack mounting frame on the server until the front of the server protrude a
little from the frame.
5. Replace the front panel.
NOTE:
we recommend you do not replace the right side door in order to facilitate service
or maintenance.
6. Align the rack mounting frame (A in figure 5) with the rear of the front panel (B in
figure 5).
7. Secure the frame with the grubscrews (C in figure 5, four on each side) using the hex
key (C in figure 1), enough to fix the frame to the server but not too much to prevent
damage to the server case.
Rack-Mount Kit H-5