Table of Contents
Advertisement
Option
Parameter
Boot monitor
[Retry 3 Times]
Policy*
Retry Service
Boot
Always Reset
Thermal Sensor
Disabled
[Enabled]
Platform Event
Disabled
Filtering*
[Enabled]
* Displayed only when Remote Management Card (option) is installed.
The table below shows the operation when the AC power to the server is turn off once and then on again, depending on
the setting of "AC LINK."
System status before AC power off
Operating
Aborting (DC power being off also)
Forced shutdown
* Press the power switch continuously for four seconds or longer. This forcibly turns off the power.
IMPORTANT:
To power on the server from the UPS (Uninterruptible Power Supply), select [Server] -
[AC Link] - [Power On].
If the server is connected to the UPS, set at least 10 seconds delay in the power-on
schedule.
Description
Specify the processing at the
occurrence of timeout during boot
monitoring.
If [Retry 3 times] is selected, the system
is reset after the occurrence of timeout
and OS boot is retried up to three times.
If [Retry Service Boot] is selected, the
system is reset after the occurrence of
timeout and OS boot is retried up to
three times. Then the boot is tried from
the service partition for three times. The
failure in the third boot causes the
system to stop booting.
If [Always Reset] is selected, the
system is reset after the occurrence of
timeout and OS boot is retried
repeatedly.
* If no service partition exists in the
system, OS boot is retried repeatedly
from the system partition.
Specify whether to enable or disable the
thermal sensor monitoring function. If a
thermal error is detected with this item
being set to "Enabled", the system
stops at the end of POST.
This item becomes meaningless when
the notification feature of remote
management card (RMC) is enabled.
Setting of AC LINK
Stay Off
Last State
Off
On
Off
Off
Off
Off
Configuring Your Server 4-21
Your Setting
[
]: Factory-set
Power On
On
On
On
Advertisement
Table of Contents
