Table of Contents
Advertisement
8.
Connect the interface and power cables to the 5.25-inch device installed from one side of the server.
See Chapter 10 for details.
NOTE:
Connect the interface cable of the floppy disk drive so that the end with the red
line indicating pin 1 faces the mother board.
Floppy disk drive
9.
Assemble the server.
10.
Set the parameters including the transfer rate using the BIOS utility of the SCSI controller.
Refer to the manual provided with the SCSI controller for details.
11.
Install the device driver for the installed device.
Refer to the manual provided with the device for details.
CD-ROM drive
REAR
Red line
Upgrading Your Server 9-33
FRONT
Advertisement
Table of Contents
