Other Mvp-Wcs-52 Installations - AMX Modero ViewPoint MVP-5200i Operation/Reference Manual

Accessories

Other MVP-WCS-52 installations

The Wall-Mounted Charging Station is designed to be installed in various different locations, such as into the
face of a wooden podium or the top of a table. Depending upon the ability to wire it to a power source, Wall-
Mounted Charging Stations may be installed on vertical or horizontal surfaces composed of such materials as
wood, brick, and glass.
Installing a Wall-Mounted Charging Station into a solid wall thicker than a standard thickness of sheetrock is
possible, but requires special preparation. If installing into a solid wall of concrete or rock, a recess must be
chiselled or cut out to match the size of the device. The box is sized 8.375 inches (21.27cm) long and 5.75
inches (14.60cm) high, so the hole should be at least 1/4" (0.64cm) smaller in these dimensions. To facilitate
the full range of movement of the device's components, the recess must be at least 2.69 inches (6.83cm) deep.
Ensure that the power cable has been installed in the wall and is accessible by the
installer before chiseling out the recess.
Instead of using the lockdown wings to secure the Plastic Back Box, standard
concrete screws may be inserted through the screw holes after removing the
lockdown wings.
However, drill the concrete screw holes into the wall before setting the screws into the
box, as excessive torque applied to the screws will damage the box.
To avoid this, the box may be installed with adhesive. Test an unobtrusive spot on the
back of the box with a sample of the adhesive to check for any adverse reactions
before installing the device.
18 MVP-5200i Modero® ViewPoint® Touch Panel with Intercom, 5.2 and 5"