Kodak DryView 8300 Service Manual page 72

SERVICE MANUAL
4. Rotate the capstan several times while observing the switch arm.
5. Rotate the capstan to where the arm movement reaches the maximum point of travel (arm in the
position that is closest to the top of the unit).
6. Adjust the screw on the arm to where the switch initially actuates, and then tighten it one quarter turn
clockwise.
7. Rotate the capstan several times to verify that the switch does not deactuate.
8. Insert the 4-mil test film between the capstan roller and the upper pinch roller.
9. Turn the flywheel counterclockwise to drive the film between the capstan roller and the lower pinch
roller.
10. Verify that the switch deactuates. If not, back off the adjustment screw to the point where the switch
just deactuates.
11. Remove the film, and verify that the switch actuates.
3-10
Left Side View
Upper
Pinch
Roller
Lower
Pinch
Roller
Flywheel
Figure 3-9.
Capstan Roller
1908110 2004 December Rev. S