Kodak DryView 8300 Service Manual page 34

SERVICE MANUAL
Parameter
1. ASPECT RATIO
(Applies to Target Mode
only.)
5. SCSI INTERFACE
1. SCSI ROLE
2. SCSI UNIT ID
3. SCSI BUS
TERMINATION (P5 only)
4. CONFIGURE USER
DEFAULTS
MODALITY GROUP
6. MARK INSTALL DATE
7. MEMORY MANAGEMENT
2-16
Table 2-4. Setting the SCSI Installation Parameters
Options
0.50 to 2.00
Select options listed below:
INITIATOR or TARGET
0 through 7 (7 is default)
ON or OFF
0 to 4
Date of Install:
day/month/year
A= 3.75 MB -- 27.75 MB
B= 4.00 MB
Action
For Target Mode: Set to 1.0.
After making a first image,
changes to this value may be
necessary.
For Initiator Mode: Users can
set this parameter. It can be
changed from the "General
Setup" menu and uses the DISK
user number.
Set to INITIATOR. The IMAGER
will be a dumb PRINTER in
TARGET mode but this role is
not supported currently.
For INITIATOR, set to 0 or 7. For
TARGET, select from 1 through
6. The unit ID cannot be a
number used by any other SCSI
DEVICE connected to the
IMAGER.
Set to ON if the IMAGER
contains an internal MO DRIVE
and no devices are connected to
P5. See paragraph 2-3 in SCSI
INPUT MODULES.
Defaults to Group 0, which is
acceptable to most applications.
If date is incorrect, change
Date/Time parameter in the
"General Setup" menu.
Partition memory across 2 input
modules as necessary. If only 1
MODULE is used, all memory
should be set to that input. The
SCSI INPUT MODULE (usually
B) should be set up to have
exactly 4 MB and the rest of the
memory should be given to the
other input, if present. See
paragraph 2--6.
1908110 2004 December Rev. S