Kodak DryView 8300 Service Manual page 35

Parameter
8. CALIBRATION ENABLE
9. MODULE ID
10. EXPOSURES
11. CAL PROCESSOR CENTER
TEMP
1. MEASURED CENTER
ZONE READING ZONE READING
12. CAL PROCESSOR END
TEMP
1. MEASURED END ZONE
READING
13. ENERGY SAVER OPTION
14. IMAGE VIEWING
17. PM EXPOSURES
18. FILM COUNT ENABLE
(effective with Version 4.9)
2004 December Rev.S 1908110
Options
ON or OFF
Input module can be renamed for
the local display.
None
None
None.
ON or OFF
EMULSION or AH (anti-halation)
Set to 0 at installation. Causes
"SCHEDULE PM" to be
displayed on the LOCAL PANEL
when 10,000 films have been
printed.
ON or OFF
INSTALLATION INSTRUCTIONS
Action
Leave at ON (default). Allows a
calibration to be done when the
film TRAY is inserted, if a print is
requested after the IMAGER is
not used for 8 hours and when
the IMAGER is energized.
Provide the INPUT MODULE
with another name, not more
than 8 characters, if necessary.
Use the instructions in the
"Module ID" menu.
Do not change. The exposure
number indicates the total film
count processed by the CPU
BOARD in the IMAGER.
Do not adjust at installation.
Current temperature is displayed Current temperature is displayed
and can range from 112.8 --
140.6° F. This parameter is used
in the procedure for Setting Up
the PROCESSOR Temperature.
Same as above.
Leave at OFF. If set to ON,
HEATERS and MOTORS will
de-energize after 3 hours if the
IMAGER is not used. This option
is not programmable.
Leave at EMULSION (except if
necessary to change).
Reset to 0 when PM has been
completed. "SCHEDULE PM"
message will be removed from
the LOCAL PANEL.
Set to ON to allow the number of
remaining films in the FILM
TRAY to be displayed on the
LOCAL PANEL.
2-17