Kodak DryView 8300 Service Manual page 181

The following is a "help" example:
Enter Selection: help
SNX Command Help
Add default router:
route add default <gateway ip address> 1
Remove router entry:
route delete <destination ip address>
<gateway ip address>
Display Routing Table:
netstat --nr
Ping network device:
ping --n <device ip address>
Display network ports in use:
netstat --na
Temporarily change ip address:
ifconfig lg0 inet <new ip address>
Temporarily change netmask:
ifconfig lg0 inet netmask <new netmask>
The following is an example of the procedure for adding a default router:
Enter Selection: route add default 163.228.152.1
Default router <163.228.152.1> saved to nvram
usage: add destination gateway metric
(metric of 0 if gateway is this host)
The following is an example of a High Level DICOM Trace (descriptions in parentheses):
Debug Menu
1. Print High Level DICOM trace
2. Print Low Level DICOM trace
3. Print 952 trace
4. Turn off DICOM trace
5. Display Ethernet nvram contents
99. Exit Debug Menu
else 'route, ping, netstat, ifconfig, help'
Enter Selection: 1
High level DICOM communications trace enabled, all other disabled
New association starting, NID 'AnySCU_163.228.142.119'
Incoming DICOM message from AnySCU_163.228.142.119: (incoming from client AnySCU
****** Begin Command Set ******
(00000002) Affected SOP Class UID
'1.2.840.10008.5.1.1.1' Basic Film Session
(00000100) Command Field
0x0140 320 N--Create RQ
(00000110) Message ID
0x0001 1
****** End Command Set ******
****** Begin Data Set ******
****** End Data Set ******
2004 December Rev. S 1908110
(client is requesting a session)
163.228.142.119)
(command set is sent to make the request)
(the request is a Basic Film Session)
(the request is a "Normalized--Create")
(no settings data specified in this
transmission)
TROUBLESHOOTING
7-13