Kodak DryView 8300 Service Manual page 211

Problem -- Cannot feed film, but all CLUTCHES and MOTORS seem to be operating correctly.
1. Cause -- Check that an Allen head SET SCREW has not loosened from one or more PULLEYS in
the
2. Cause -- Light weight FILM FEED ROLLER has torn loose from its SHAFT.
1. Solution -- Tighten all PULLEYS on the flat part of the SHAFT to which they are connected.
2. Solution -- Replace the FILM FEED ROLLER.
TECH TIPS
If the FILM DETECT SWITCH cannot sense a FILM OUT condition it may try to feed the film liner.
If the Registration Foam in the Film Tray appears to be providing too much resistance to the film (which
would be most obvious when only a few sheets remain in the Film Tray), cut and remove the middle 2
inches of the Registration Foam on the left side of the Film Tray. This will leave two 2-inch pieces of foam
in the Film Tray, which will reduce the overall resistance by 30%.
THEORY
2004 December Rev. S
film feed area.
1908110
TROUBLESHOOTING
7-43