Kodak DryView 8300 Service Manual page 170

SERVICE MANUAL
3. PRINT MODE = SINGLE
TO CHANGE PRESS ARROW, THEN ENTER
4. PATTERN = SMPTE
ENTER TO CHANGE OR PRESS ARROW FOR
OTHER ITEMS
4. PATTERN = SMPTE
TO CHANGE PRESS ARROW, THEN ENTER
5. PATTERN = SMPTE
ENTER TO START OR PRESS ARROW FOR
OTHER ITEMS
4. PERFORM CHECKSUM TEST
ENTER TO START OR PRESS ARROW FOR OTHER
ITEMS
5. PERFORM TRANSPORT TEST
ENTER TO START, PRESS ARROW FOR OTHER
ITEMS
5. A=1 B=0 C=0 D=1 E=0 F=0 G=0 H=0
6. PERFORM DRAM TEST
ENTER TO START, PRESS ARROW FOR OTHER
ITEMS
7. SERVICE PORT BAUD RATE = 38,400
ENTER TO START, PRESS ARROW FOR OTHER
ITEMS
7-2
Menu Display Options/Actions
Selections are: SMPTE
Vertical Wedge
Horizontal Wedge
Test images are always printed with
Modality Group 1.
This is a quick RAM test. If the IMAGER
fails the test, an error is displayed.
Indicates when SENSORS are activated,
and runs film without exposing it. If the
film is not clear when it exits, 1 or more of
these conditions might be the cause:
exposed, fogged, or aged film, or
exposure from light leaks.
Note: The IMAGER feeds film
continuously during this test until Exit is
pressed.
0 = OFF
1 = ON
A = Film Tray In Place Switch
B = Film Saver In Place Switch
C = Film Out Switch
D = One Sheet Sensor
E = Two Sheet Sensor
F = Capstan Media Sense Switch
G = Processor Entrance Sensor
H = Processor Exit Sensor
This is a more extensive RAM test than
the Checksum Test. Note: The DRAM
Test continues to run until Exit is pressed.
Selections are: 1,200
2,400
4,800
9,600
19,200
38,400
1908110 2004 December Rev. S